Netinstall

[Tomáš Nesrsta]

mam tu 411 ktera po upgradu uz nenajela. Tak jsem na Win7 rozjel netinstall a vysledek je tenhle:
RouterBOOT booter 2.12

RouterBoard 411

Authorization: Passed
CPU frequency: 300 MHz
Memory size: 32 MB

Press any key within 2 seconds to enter setup.

RouterBOOT-2.12
What do you want to configure?
d - boot delay
k - boot key
s - serial console
o - boot device
u - cpu mode
f - cpu frequency
r - reset booter configuration
e - format nand
g - upgrade firmware
i - board info
p - boot protocol
x - exit setup
your choice: g - upgrade firmware

Upgrade firmware options:
e - upgrade firmware over ethernet
s - upgrade firmware over serial port
your choice: e - upgrade firmware over ethernet


trying bootp protocol... OK
Got IP address: 10.1.1.5
resolved mac address 6C:62:6D:B0:F8:84
transfer started ......................... transfer ok, time=1.74s
invalid upgrade file id

Upgrade firmware options:
e - upgrade firmware over ethernet
s - upgrade firmware over serial port
your choice: exit

RouterBOOT-2.12
What do you want to configure?
d - boot delay
k - boot key
s - serial console
o - boot device
u - cpu mode
f - cpu frequency
r - reset booter configuration
e - format nand
g - upgrade firmware
i - board info
p - boot protocol
x - exit setup
your choice: o - boot device

Select boot device:
e - boot over Ethernet
* n - boot from NAND, if fail then Ethernet
1 - boot Ethernet once, then NAND
o - boot from NAND only
b - boot chosen device
your choice: 1 - boot Ethernet once, then NAND

RouterBOOT-2.12
What do you want to configure?
d - boot delay
k - boot key
s - serial console
o - boot device
u - cpu mode
f - cpu frequency
r - reset booter configuration
e - format nand
g - upgrade firmware
i - board info
p - boot protocol
x - exit setup
your choice: x - exit setup


writing settings to flash... OK


RouterBOOT booter 2.12

RouterBoard 411

Authorization: Passed
CPU frequency: 300 MHz
Memory size: 32 MB

Press any key within 2 seconds to enter setup..
writing settings to flash... OK
trying bootp protocol... OK
Got IP address: 10.1.1.5
resolved mac address 6C:62:6D:B0:F8:84
**transfer started ......................... transfer ok, time=1.97s
setting up elf image... OK
jumping to kernel code
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(0,0)


Dokaze me nekdo nakopnout co delam spatne?

[hapi]

Kód: Vybrat vše

Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(0,0)

použij starší netinstal třeba z v3.30 nebo v4.17. Nemáš tam poslední bios kterej umí číst novej file system... teoreticky.

Pokud ti netinstall naběhne ale nedokáže nakopírovat balíčky do rbčka tak budeš muset použív WinXP. Sral jsem se s tim v pátek.

[Tomáš Nesrsta]

Díky, 4.17 taky blbla ale s 3.30 uz to jede v pohode. i pod Win7, a ja uz kvuli tomu nainstaloval i WinXP.