Kód: Vybrat vše
[admin@MikroTik] interface> print
Flags: X - disabled, D - dynamic, R - running
# NAME TYPE RX-RATE TX-RATE MTU
0 R ether1 ether 0 0 1500
1 wlan1 wlan 0 0 1500
2 wlan2 wlan 0 0 1500
0 name="wlan1" mtu=1500 mac-address=00:0B:xx:xx:xx:xx arp=enabled
disable-running-check=no interface-type=Atheros AR5213
radio-name="000B6B4DFBE7" mode=station ssid="123456" area=""
frequency-mode=manual-txpower country=slovak republic antenna-gain=0
frequency=5540 band=5ghz scan-list=default rate-set=default
supported-rates-b=1Mbps,2Mbps,5.5Mbps,11Mbps
supported-rates-a/g=6Mbps,9Mbps,12Mbps,18Mbps,24Mbps,36Mbps,48Mbps,
54Mbps
basic-rates-b=1Mbps basic-rates-a/g=6Mbps max-station-count=2007
ack-timeout=45 tx-power=17 tx-power-mode=all-rates-fixed
noise-floor-threshold=default periodic-calibration=default
periodic-calibration-interval=60 burst-time=disabled dfs-mode=none
antenna-mode=ant-b wds-mode=disabled wds-default-bridge=none
wds-default-cost=100 wds-cost-range=50-150 wds-ignore-ssid=no
update-stats-interval=disabled default-authentication=yes
default-forwarding=yes default-ap-tx-limit=0 default-client-tx-limit=0
hide-ssid=no security-profile=def
on-fail-retry-time=100ms preamble-mode=both compression=no
allow-sharedkey=no
1 name="wlan2" mtu=1500 mac-address=00:0B:xx:xx:xx:xx arp=enabled
disable-running-check=no interface-type=Atheros AR5213
radio-name="000B6B4DF888" mode=ap-bridge ssid="abcdef"
area="" frequency-mode=manual-txpower country=slovak republic
antenna-gain=0 frequency=5500 band=5ghz scan-list=default
rate-set=default supported-rates-b=1Mbps,2Mbps,5.5Mbps,11Mbps
supported-rates-a/g=6Mbps,9Mbps,12Mbps,18Mbps,24Mbps,36Mbps,48Mbps,
54Mbps
basic-rates-b=1Mbps basic-rates-a/g=6Mbps max-station-count=2007
ack-timeout=51 tx-power=17 tx-power-mode=all-rates-fixed
noise-floor-threshold=default periodic-calibration=default
periodic-calibration-interval=60 burst-time=disabled dfs-mode=none
antenna-mode=ant-b wds-mode=disabled wds-default-bridge=none
wds-default-cost=100 wds-cost-range=50-150 wds-ignore-ssid=no
update-stats-interval=disabled default-authentication=yes
default-forwarding=yes default-ap-tx-limit=0 default-client-tx-limit=0
hide-ssid=no security-profile=default disconnect-timeout=3s
on-fail-retry-time=100ms preamble-mode=both compression=no
allow-sharedkey=no
[admin@MikroTik] ip address> print
Flags: X - disabled, I - invalid, D - dynamic
# ADDRESS NETWORK BROADCAST INTERFACE
0 192.168.4.193/26 192.168.4.192 192.168.4.255 ether1
1 192.168.1.33/24 192.168.1.0 192.168.1.255 wlan1
2 192.168.5.195/26 192.168.5.192 192.168.5.255 wlan2
[admin@MikroTik] ip route> print
Flags: X - disabled, A - active, D - dynamic,
C - connect, S - static, r - rip, b - bgp, o - ospf
# DST-ADDRESS PREFSRC G GATEWAY DISTANCE INTERFACE
0 ADC 192.168.1.0/24 192.168.1.33 wlan1
1 ADC 192.168.4.192/26 192.168.4.193 ether1
2 ADC 192.168.5.192/26 192.168.5.195 wlan2
3 S 0.0.0.0/0 u 192.168.1.1
wlan1 sa pripaja na AP s IP adresou 192.168.1.11
gateway ma IP 192.168.1.1
z mikrotiku mi ping na 192.168.1.1 funguje
nefunguje mi ping na 192.168.1.1 z pocitaca, ktory je pripojeny na ethernet mikrotiku, na mikrotik sa dopingam
co mam zle nastavene?