vycitani hodnot z ups do logu
Napsal: 11 Jun 2010 10:01
Zdravim, chtel jsem se zeptat, jestli jde nejak jednoduse v mikrotiku, kdyz mam ups pripojenou pres seriak poslat do logu informace z
"/system ups monitor ups1" Standartne mi to pouze vypise napr:
on-line: yes
on-battery: no
rtc-running: no
runtime-left: 35m
battery-charge: 100%
battery-voltage: 13.77V
line-voltage: 230.4V
output-voltage: 230.4V
load: 27%
frequency: 50Hz
replace-battery: no
smart-boost: no
smart-trim: no
overload: no
low-battery: no
kdyz nektere hodnoty chci vycist pres "get" do promenne a pak vypsat tak mi nic nevyctou. Nevite nekdo jiny zpusob jak je dostat do logu nebo do nejake promenne? jde mi hlavne o runtime-leff a temperature.
pri "/system ups get ups1" mi to nabizi pouze "alarm-setting disabled load min-runtime name offline-after on-line serial value-name
comment invalid manufacture-date model nominal-battery-voltage offline-time port version "
Nevite nekdo jak vycist zbytek info?
Predem diky.
"/system ups monitor ups1" Standartne mi to pouze vypise napr:
on-line: yes
on-battery: no
rtc-running: no
runtime-left: 35m
battery-charge: 100%
battery-voltage: 13.77V
line-voltage: 230.4V
output-voltage: 230.4V
load: 27%
frequency: 50Hz
replace-battery: no
smart-boost: no
smart-trim: no
overload: no
low-battery: no
kdyz nektere hodnoty chci vycist pres "get" do promenne a pak vypsat tak mi nic nevyctou. Nevite nekdo jiny zpusob jak je dostat do logu nebo do nejake promenne? jde mi hlavne o runtime-leff a temperature.
pri "/system ups get ups1" mi to nabizi pouze "alarm-setting disabled load min-runtime name offline-after on-line serial value-name
comment invalid manufacture-date model nominal-battery-voltage offline-time port version "
Nevite nekdo jak vycist zbytek info?
Predem diky.