classic.ISPforum.cz

What's new in 6.14 (2014-Jun-06 15:34):

*) sntp - 'mode' now is a read-only property, it is set to broadcast if no
server ip address is specified;
*) smb - fixed some SMB1 errors;
*) wireless-fp package is now included in routeros one (disabled by default);
*) webfig - fixed quickset, it didn't work with disabled wireless pacakge;
*) sstp - fixed problem where session was closed every 2min;
*) pptp,l2tp,pppoe - fixed problem where some of the static bindings
become dynamic interfaces;
*) eoip - lowered default MTU to avoid IP packet fragmentation;
*) eoip - added clamp-tcp-mss setting with default=yes for new tunnels to avoid
IP packet fragmentation;
*) fixed - bridge could sometimes get added without "running" flag;
*) fixed - simple queues could sometimes crash router;
*) fixed - simple queue stats freeze (empty winbox queue window);
*) ssh server - allow none cipher;
*) proxy - added 'anonymous' option which will skip adding X-* and Via headers;
*) dhcp server - added option use-framed-as-classless and
added support for DHCP-Classless-Static-Route RADIUS attribute;
*) quickset - fixed problem where address mode selection did not work in
bridge mode;
*) ipv6 address - fixed problem where changing advertise lost ipv6 connected route;

CAVEAT: CAPsMAN Layer3 doesn’t work if IPv6 package enabled either
on CAPsMAN or CAP device;

Když se odinstaluje balíček wireless-fp, tak se disabluje balíček wireless a už nejde enablovat. Je pak nutný downgrade aby se opět nainstaloval balíček wireless a pak to jde zas enablovat ovšem se ztrátou nastavení wifin tak bacha na to.

Jsou to kopyta. Zkuste si změnit SNTP klienta na unicast ve winboxu. Nejde ... musí se do CLI.

takze 6.14 nefunkcna?

Na jiný problém jsem zatím nenarazil. Ale je to moc brzo, něco prohlásit. Jenže když jsou schopni podělat takovouhle hloupost, co X let fungovala ...

Neupgradujete z verze 5.x na 6.14 (hrozí ztráta nastavení bezdrátu)

What you might see is that DHCP and Wireless menus are gone after upgrade. After a reboot, the menus appear, but the config is lost. Reconfiguration is needed. We will try to release a fix soon.

RB493 po upgrade uplne vytuhlo a musel jsem pres "network upgrade" nahrat zpatky nizsi verzi. Na RB1100AHx2 se rozhodila konfigurace SNTP a ani se nesyncne a ani neposkytuje sluzbu. Tohle byl od chlapcu krok zpet.

Mě se 493 aktualizoval ale bylo potřeba odpojit/zapojit napájení aby naběhl

Takovy stesti jsem nemel. Ale dam mu dnes druhou sanci a zkusim upgrade znovu.

honzam píše:Mě se 493 aktualizoval ale bylo potřeba odpojit/zapojit napájení aby naběhl